Gulistan Carpet

“We rely on steam for the dyeing process, and with previous steam boilers, we would have to wait at least two hours for steam to be produced. This resulted in labor inefficiencies and higher fuel costs. With the Miura boilers, we can have steam just a few minutes after startup. Since being installed, we estimate that we are saving an average of $24,000 each month on labor and fuel costs. The Miura boilers have significantly improved the efficiency of the Wagram (NC) facility.” – Jack Avant, Engineering Manager, Gulistan Carpet

“Our steam load varies from 5,000 PPH (Pounds Per Hour) to 50,000 PPH, so we were looking for a dependable and reliable boiler system that could give us the proper amount of steam for the low- and high-demand times. Our previous boilers could not run on low loads, and the efficiency would decrease drastically. The Miura boilers are very efficient and environmentally friendly, and require very little attention when operating, plus they take up a lot less room.” –Avant

“The Miura boilers have performed very well. We contacted several boiler companies, and we did not find a single competitor that could meet our requirements. Miura’s efficiency is essential to meeting our performance needs and the fuel savings and the labor savings are very important to our bottom line.” – Avant

Viscotec Automotive Products

“We chose Miura boilers because the quick start-up time and their ease-of use. We believe in the technology so strongly that we’ve been a Miura customer from the day we opened our doors. The reduced time to produce steam means that our fuel costs are lower, which is another major benefit we’ve gotten from these boilers.” – Will Fritz, Plant Engineer, Viscotec Automotive Products

“I initially had my reservations about them, because I had previously worked with coal-fired boilers, and the idea of producing steam in five minutes seemed too good to be true. But once I saw what these boilers could do, and how well they did it, I knew that going with Miura was the right decision. The boilers have performed wonderfully.” – Fritz

Duke Raleigh Hospital

“Right now North Carolina is in a drought situation. I’m attending lots of meetings on what can be done about water conservation and Miura boilers, because they are so small and efficient, have really put us way ahead of everybody around town – and this industry – on water conservation.”  – Shannon Clifton, Engineering Supervisor, Duke Raleigh Hospital

“We’ve had Miura boilers here for about three years. Our first two paid for themselves in about a year on fuel savings alone.”  – Clifton

“We found the savings with Miura over our previously-owned fire tube boilers, from one month to the next, was at least a thousand Decatherms. In fact, the lowest number I had was 1200 and the highest was about 1600.  With the new unit, we found we saved another 100 to 200 Decatherms beyond that each month.” – Clifton

“I’m constantly getting phone calls from people across the nation because we are using the boilers in a hospital setting where there are different characteristics and/or uses. People want to know about different day-to-day questions like water treatment, and other questions. Since we work with Miura boilers on a day-to-day basis and we’re not sales people, we attract a good many questions.” – Clifton

“The efficiency is essential to meeting our needs, the fuel savings are important to our bottom line. I’d highly recommend Miura’s boilers.” – Clifton

Spangler Candy

“We were running a pretty efficient operation, but with Miura technology, we estimated an additional 10 to 20% fuel saving, and that really got our attention.” – Paul Gackel, PE, Director of Facilities/Utilities, Spangler Candy

“I felt very confident that we would satisfy our needs with Miura boilers and achieve the fuel cost savings that would enhance our productivity. The first month we could test actual fuel costs “apples to apples,” the results suggested a savings of 14.87% on fuel costs and the additional benefit or conserving natural resources.” – Gackel

“Miura boilers can step down easily and having good control of output pressure made a big difference for us in achieving our goals. Plus, even though the Miura technology was new to our operators, they did seem to like it a lot more than our previous boiler, since with the self-diagnostics there was a lot less to go wrong.” – Gackel